HP Surestore 600fx Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 13
Drives mounted - enclosure top access plate
View all HP Surestore 600fx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Figure 10: Drives mounted - enclosure top access plate on j. Re-install the top drive cable access panel on the drive enclosure by replacing and tightening the 2 T-10 screws that previously held the cover in place. (Tighten the screws holding the bottom access panel if they were loosened. Note At this point, verify that the cables are connected properly to the drives. They are installed properly if they can be laid flat against the side of the drive enclosure. In this position, the air seal can easily be mounted (Step 10). 9. Install (remove the sticky backing and attach) the "L-shaped" air seal on drive enclosure hole as indicated in Figure 8. The small square air seal should be attached over the air flow hole on the other side of the drive enclosure. 13