HP Surestore 600fx Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 15

b. Replace and tighten the 2 T-20 (RLG) screws that mount each side of the drive enclosure. Plug the drive cables into the interposer PCA in the following order: 1 - drive interface cable (use the one UNDER the SCSI cable connector) 2 - SCSI cable 3 - fan power cable 4 - power cable (over the SCSI cable) Use the drive cables mounted on the upper interposer PCA as a guide. Note If you are upgrading this jukebox to a TOTAL of 8 drives or 10 drives, you must plug a capacitive load (terminator) to one of the SCSI cable connectors on the lower interposer PCA. If one already exists on that jukebox, use that one - do not add the one from the kit. If you are upgrading the unit to 12 drives, discard the terminator if it is already mounted on that jukebox - the one from the kit may be discarded also. 11. (If upgrading to an 8-drive jukebox.) Plug the capacitive load (terminator) into one of the lower two connectors on the lower interposer PCA. Figure 13: Capacitive load (terminator) 15