HP Surestore 600fx Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 4

Tools Required The following tools are needed for assembly/disassembly of the autochanger: • Torx driver with the following bits: T-10, T-20 Kit Contents Check the conversion kit to make sure you have the following parts: • 2 - 4X drives - # C1113-60x00 • 1 - drive interface cable - # C1107-60x63 • 1 - drive power cable - # C1107-60x55 • 1 - drive SCSI cable - # C1107-60x46 • 2 - drive interface cable clamps - # 1400-0611 • 1 - capacitive load (terminator) - C1108-61600 • 1 - drive bracket air seal - # C1107-80604 • 10 - M3x6 T10 screws - # 0515-2382 • 2 - product upgrade label sheets (Upgrade to: ) - # 5181-9902 • 1 - these instructions Note This document is not necessarily revised as each part number is revised. In the above list, an "x" is placed in "service" part numbers (parts orderable from Support Materials Organization) to designate that this digit increments when the part is revised. This digit usually starts at "0" and increments up to "9." Knowing this should help you locate the correct part at SMO. For any other parts that may be missing from this kit, contact your supplier. 4