HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director 2/64 Installation Guide ( - Page 57
AC power connections, HP System/e and Industry-Standard 19-in Rack Installation
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Installing and Configuring the Director 2/64 9. Connect the equipment rack power cords to separate (for redundancy) facility power sources, providing single-phase, 120 to 240 VAC current. Figure 14: AC power connections HP System/e and Industry-Standard 19-in Rack Installation To install the director in a HP system/e or industry-standard 19-in rack, complete the procedures in the following sections: ■ Install the Anti-tip Feet on a HP System/e Rack, page 57 ■ Install Mounting Bracket Hardware in the Rack, page 58 ■ Prepare the Front and Rear Rack Columns, page 62 ■ Prepare the Switch for Installation, page 63 ■ Finalize the Rack Mounting Procedure, page 65 ■ Sliding Shelf Installation-For an HAFM Server only, page 67 ■ Recommended Cable Management, page 70 Install the Anti-tip Feet on a HP System/e Rack Use the following procedure to mount anti-tip feet on a HP system/e rack only, as shown in Figure 15: 1. Place the anti-tip feet (1), provided in the HP system/e and industry-standard 19-in rack mount kits on the front and rear of the rack base. 2. Secure the anti-tip feet (1) to the base of the rack (front and rear). Director 2/64 Installation Guide 57