HP TouchSmart 300-1300 Upgrading and Servicing Guide
HP TouchSmart 300-1300 - Desktop PC Manual
 |
View all HP TouchSmart 300-1300 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP TouchSmart 300-1300 manual content summary:
- HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 1
*584963-001* *584963-001* Printed in HP Touchsmart300 PC Upgrading and Servicing Guide Replacing a Wireless Keyboard or Mouse .......2 Before You Begin 2 Replacing the Keyboard or Mouse 2 Replacing Batteries 3 Upgrading or Replacing Memory 6 Before You Begin 6 Computer Preparation 6 Removing - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 2
ii 584963-001 - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 3
HP Touchsmart300 PC Replacing a Wireless Keyboard or Mouse - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 4
Begin Two replacement kits are available: z Wireless keyboard z Wireless mouse with wireless receiver IMPORTANT: The keyboard and mouse must be next to the HP PC, within 1 foot (30 cm) and away from interference with other devices. Replacing the Keyboard or Mouse 1 Leave the computer on. 2 If you - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 5
5 If you are replacing the mouse and it has a power switch on the bottom, turn on the mouse power switch (A). The keyboard does not have a power switch, so you can skip this step if you are installing the keyboard only. 6 Press the blue connect button on the bottom of the keyboard (B) and/or mouse - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 6
4 584963-001 - Replacing a Wireless Keyboard or Mouse - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 7
HP Touchsmart300 PC Upgrading or Replacing Memory - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 8
Upgrading or Replacing Memory 5 - 10 minutes Before You Begin Observe the following requirements before removing and replacing memory cards. Tools Needed z Torx or flat screwdriver - medium tip CAUTION: Static electricity can damage the electronic components inside the computer. Discharge static - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 9
Removing the Memory 6 Lift the plastic shield on the back of the computer stand. 9 Use your fingers to press outwards on the tabs on the left and right sides of a memory card to release it. 7 Use a torx or flat-head screwdriver to remove the screw that secures the right cover. 10 Hold the card by - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 10
Installing a New Memory Card 1 Orient the new card so that the notch on the edge of the card faces forward and is on the right. 4 Slide the right cover into place. 2 Holding the card by its edges, slide it all the way into the slot. 5 Replace the right cover screw. 3 Gently push downward on the - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 11
cord into the back of the computer and then into the power source. 8 Return the computer to the upright position and turn on the computer. Troubleshooting [This section needs to be verified and/or modified for M5. It was copied from Amazon.] If the computer displays a memory error after you have - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 12
10 584963-001 - Upgrading or Replacing Memory - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 13
HP Touchsmart300 PC Removing and Replacing a Hard Disk Drive - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 14
Removing and Replacing a Hard Disk Drive 5 - 10 minutes Before You Begin Observe the following requirements before removing and replacing the hard disk drive. Tools Needed z Torx or flat screwdriver - medum-sized tip CAUTION: Static electricity can damage the electronic components inside the - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 15
Removing the Hard Disk Drive 6 Lift the plastic shield on the back of the computer stand. 9 Loosen the screw at the bottom of the hard disk drive cage. TIP: You do not need to remove this screw, only loosen it in order to release the hard disk drive cage. 7 Use a torx or flat-head screwdriver to - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 16
12 Remove the four screws that hold the drive in the cage. Remove the drive from the cage. Installing a New Hard Disk Drive 1 Insert the new hard disk drive into the cage. Make sure that the hard drive is inserted with the label on the bottom. 2 Install and tighten the four screws that hold the - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 17
4 Align the wheels on each side of the top of the hard disk drive cage with the slots in the hard disk drive bay, and insert the hard disk drive. 7 Slide the left cover into place. 5 Press down on the hard disk cage handle to snap it into place. 8 Replace the left cover screw. 6 Tighten the - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 18
11 Return the computer to the upright position and turn on the computer. 16 584963-001 - Removing and Replacing a Hard Disk Drive - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 19
HP Touchsmart300 PC Removing and Replacing a CD/DVD Drive - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 20
Removing and Replacing a CD/DVD Drive 5 - 10 minutes Before You Begin Observe the following requirements before removing and replacing the CD/DVD drive. Tools Needed z Torx or flat-head screwdriver - medum-sized tip z Very small Phillips screwdriver CAUTION: Static electricity can damage the - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 21
Removing the CD/DVD Drive 6 Lift the plastic shield on the back of the computer stand. 9 Loosen the screw at the back of the CD/DVD drive cage. TIP: You do not need to remove this screw, only loosen it in order to release the CD/DVD drive cage. 7 Use a torx or flat-head screwdriver to remove the - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 22
11 Disconnect the cable on the right-hand side of the CD/DVD drive cage. 13 Slide the CD/DVD drive forward to remove it from the cage. 12 Use the small Phillips screwdriver to remove the four screws that secure the CD/DVD drive in the cage. Two screws are on each side. TIP: These screws are very - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 23
Installing a New CD/DVD Drive 1 Insert the new CD/DVD drive into the cage. Orient the CD/DVD drive so that the connection for the cable aligns with the opening at the rear of the cage. 3 Connect the cable to the rear of the CD/DVD drive. 2 Insert and tighten the four screws on the sides of the CD/ - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 24
6 Slide the left cover into place. 8 Reconnect any cables that were disconnected for this procedure. 9 Plug the power cord into the back of the computer and then into the power source. 7 Replace the left cover screw. 10 Return the computer to the upright position and turn on the computer. 22 - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 25
23 584963-001 - Removing and Replacing a CD/DVD Drive - HP TouchSmart 300-1300 | Upgrading and Servicing Guide - Page 26
Copyright © 2009 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. Version: 1.0
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
 |
 |
584963-001
i
Printed in
Replacing a Wireless Keyboard or Mouse
.......
2
Before You Begin
.................................................
2
Replacing the Keyboard or Mouse
.........................
2
Replacing Batteries
..............................................
3
Upgrading or Replacing Memory
....................
6
Before You Begin
.................................................
6
Computer Preparation
..........................................
6
Removing the Memory
.........................................
7
Installing a New Memory Card
.............................
8
Troubleshooting
...................................................
9
Removing and Replacing a Hard Disk Drive ..12
Before You Begin
...............................................
12
Computer Preparation
........................................
12
Removing the Hard Disk Drive
.............................
13
Installing a New Hard Disk Drive
.........................
14
Removing and Replacing a CD/DVD Drive
.....
18
Before You Begin
...............................................
18
Computer Preparation
........................................
18
Removing the CD/DVD Drive
..............................
19
Installing a New CD/DVD Drive
..........................
21
Upgrading and Servicing Guide
*584963-001*
*584963-001*
HP Touchsmart
300
PC