HP Vectra M2 hp business pcs, remote software deployment, setup guide for PXE - Page 28

RIS Server Setup

Get HP Vectra M2 - N2 PDF manuals and user guides View all HP Vectra M2 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

5.1. RIS Image Creation: Procedure to be Followed 5. RIS Server Setup If the Windows 2000 CD-ROM needs to be upgraded by a Service Pack, the CD-ROM should first be copied into a temporary folder. The Service Pack should then be applied to this folder and finally this folder should be imported as a CDROM image under RIS interface. If RIS is not yet installed, go to Start>Programs>Administrative Tools>Configure your server and click on "Networking" and then on "Remote Access". Finally, run the wizard. 1. Go to Start>Programs>Administrative Tools>Active Directory Users and Computers and then double-click on Domain Controllers. The name of the Windows 2000 server should be displayed (in this document, it is W2KSRV). 2. Right click on it and then click on Properties, and then on the Remote Install tab. Check the "Respond to client computers requesting service" box. 3. Next, click on Advanced Settings and check the New Clients tab to customize the computer names of the RIS clients. 4. Click on the Images tab, then on Add and then check the "Add a new installation image" box. 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
5. RIS Server Setup
5.1. RIS Image
Creation:
Procedure to be
Followed
If the Windows 2000 CD-ROM needs to be upgraded by a
Service Pack, the CD-ROM should first be copied into a
temporary folder. The Service Pack should then be applied to
this folder and finally this folder should be imported as a CD-
ROM image under RIS interface.
If RIS is not yet installed, go to
Start>Programs>Administrative Tools>Configure
your server
and click on “
Networking
” and then on
“
Remote Access
”. Finally, run the wizard.
1. Go to
Start>Programs>Administrative
Tools>Active Directory Users and Computers
and
then double-click on
Domain Controllers
.
The name of the Windows 2000 server should be
displayed (in this document, it is W2KSRV).
2. Right click on it and then click on
Properties
, and
then on the
Remote Install
tab. Check the
“
Respond to client computers requesting
service
” box.
3.
Next, click on
Advanced Settings
and check the
New Clients
tab to customize the computer names of
the RIS clients.
4.
Click on the
Images
tab, then on
Add
and then
check the “
Add a new installation image
” box.
28