HP Vectra VEi8 HP Vectra VEi7, Intel EtherExpress PRO 10+ ISA Ethernet Adapter - Page 16
Microsoft Windows NT, 0 Workstation, Connecting to a, Windows NT 4.0 Server, Requirements, Device
View all HP Vectra VEi8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
6 Installing the Intel EtherExpress PRO 10+ ISA Ethernet Adapter Microsoft Windows NT 4.0 Workstation 6 Installing the Intel EtherExpress PRO 10+ ISA Ethernet Adapter Microsoft Windows NT 4.0 Workstation Connecting to a Requirements Windows NT 4.0 Server • HP Vectra with Windows NT 4.0 Workstation. • Intel EtherExpress PRO 10+ ISA Ethernet card and drivers disk version 3.50. • Driver File: EPRO.SYS, version 3.66 • Microsoft Windows NT 4.0 Workstation media. • Microsoft Windows NT 4.0 Service Pack 4 media. • Microsoft Windows NT 4.0 Server system that supports NetBEUI, NWLink IPX/SPX Compatible Transport, and NWLink NetBIOS network protocols. Device Configuration Device Configuration Interrupt I/O Address Vectra Vli8 05 210 Vectra VEi7 03 210 Vectra VEi8 07 210 Procedure 1 With the HP Vectra turned off, install the Intel EtherExpress PRO 10+ ISA adapter card into an ISA slot. 2 Connect network cable media to the PRO 10+ card. 3 Power on the machine and start in MS-DOS mode. 4 Insert the Intel drivers disk, "EtherExpress Ethernet Drivers" and execute "SOFTSET2.EXE". 5 Select "CONFIGURE NIC" and verify the resource settings listed above under the heading "Device Configuration". 6 If changes are required, save those changes and exit. 7 Remove the Intel Software driver diskette and restart the system.