HP Vectra VEi8 HP Vectra VEi7, Intel EtherExpress PRO 10+ ISA Ethernet Adapter - Page 24

9 Installing the Intel EtherExpress PRO 10+ ISA Ethernet Adapter Microsoft Windows NT 3.51 Workstation 9 Installing the Intel EtherExpress PRO 10+ ISA Ethernet Adapter Microsoft Windows NT 3.51 Workstation Connecting to a Requirements Windows NT 3.51 Server • HP Vectra with Windows NT 3.51 Workstation. • Intel EtherExpress PRO 10+ ISA Ethernet card and driver disk version 3.50. • Driver File: EPRO.SYS, version 3.66 • Microsoft Windows NT 3.51 Workstation media. • Microsoft Windows NT 3.51 Service Pack 5 media. • Microsoft Windows NT 3.51 Server system that supports NetBEUI, NWLink IPX/SPX Compatible Transport, and NWLink NetBIOS network protocols. Device Configuration Device Configuration Interrupt I/O Address Vectra Vli8 05 210 Vectra VEi7 03 210 Vectra VEi8 07 210 Procedure 1 With the HP Vectra turned off, install the Intel EtherExpress PRO 10+ ISA adapter card into an ISA slot. 2 Connect network cable media to the PRO 10+ card. 3 Power on the machine and start in MS-DOS mode. 4 Insert the Intel driver disk, "EtherExpress Ethernet Drivers" and execute "SOFTSET2.EXE". 5 Select "CONFIGURE NIC" and verify the resource settings listed above under the heading "Device Configuration". 6 If changes are required, save those changes and exit. 7 Remove the Intel Software driver diskette and restart the system. 8 Log into Windows NT with administrator privileges.