HP Vectra VEi8 HP Vectra VEi7, Intel EtherExpress PRO 100B-TX PCI Ethernet Ada - Page 20

8 Installing the Intel EtherExpress Pro 100B-TX PCI Ethernet Adapter Microsoft Windows NT 4.0 Workstation 8 Installing the Intel EtherExpress Pro 100B-TX PCI Ethernet Adapter Microsoft Windows NT 4.0 Workstation Connecting to a Novell NetWare 4.11 Server Requirements • HP Vectra with Windows NT 4.0 Workstation. • Intel EtherExpress PRO 100B-TX PCI Ethernet adapter and driver disk version 2.51. • Driver File: E100BNT.SYS, version 2.24 • Microsoft Windows NT 4.0 Workstation media. • Microsoft Windows NT 4.0 Service Pack 4 media. • Novell NetWare 4.11 Server system that supports IPX network protocol. • Novell IntranetWare Client for Windows NT v4.11b installation media. Device Configuration Device Configuration Interrupt I/O Address Vectra Vli8 11 1020 Vectra VEi7 03 DCE0 Vectra VEi8 10 E400 Procedure 1 With the HP Vectra turned off, install the Intel EtherExpress PRO 100B PCI adapter card into a PCI slot. 2 Connect network cable media to the Intel EtherExpress PRO 100B card. 3 Power on the machine and start in MS-DOS mode. 4 Insert the Intel driver disk, "EtherExpress PRO/100B LAN Adapter Configuration and Drivers Diskette" and execute "SETUP.EXE". 5 Select "CONFIGURE NIC" and verify the resource settings listed above under the heading "Device Configuration". 6 If changes are required, save those changes and exit. 7 Remove the Intel Software driver diskette and restart the system.