HP mp2200 User's Guide - Page 43
Insert the new lamp module into the projector and tighten the two screws.
View all HP mp2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
5. Loosen the two screws 2 on the lamp module, and pull out the module 3. 6. Insert the new lamp module into the projector and tighten the two screws. 7. Install the cover and tighten the two screws. 8. Turn on the projector. If the lamp does not turn on after the warm-up period, try reinstalling the lamp. 9. Press enter, go to Setup > Reset lamp hours, and press enter. Performing routine maintenance 43
Performing routine maintenance
43
5.
Loosen the two screws
2
on the lamp module, and pull out the module
3
.
6.
Insert the new lamp module into the projector and tighten the two screws.
7.
Install the cover and tighten the two screws.
8.
Turn on the projector. If the lamp does not turn on after the warm-up period, try reinstalling
the lamp.
9.
Press
enter
, go to
Setup > Reset lamp hours
, and press
enter
.