HP rp7440 Site Preparation Guide, Fourth Edition - HP Integrity rx7640 and HP - Page 16

Right-Front View, Front Panel, Display Board

Get HP rp7440 PDF manuals and user guides View all HP rp7440 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

The server has the following dimensions: • Depth: Defined by cable management constraints to fit into standard 36-inch deep rack: 25.5 inches from front rack column to PCI connector surface 26.7 inches from front rack column to MP Core I/O connector surface 30 inches overall package dimension, including 2.7 inches protruding in front of the front rack columns. • Width: 44.45 cm (17.5 inches), constrained by EIA standard 19 inch racks. • Height: 10U - 0.54 cm = 43.91 cm (17.287 inches). This is the appropriate height for a product that consumes 10U of rack height while allowing adequate clearance between products directly above and below this product. Fitting four server units per 2 m rack and upgrade of current 10U height products in the future are the main height constraints. The mass storage section located in the front enables access to the 3.5-inch hard drives without removal of the bezel. This is especially helpful when the system is mounted in the lowest position in a rack. The mass storage bay also accommodates one 5.25-inch removable media device. The front panel display board, containing LEDs and the system power switch, is located directly above the 5.25-inch removable media bay. Below the mass storage section and behind the removable front bezel are two, N+1 PCI-X power supplies. The bulk power supply section is partitioned by a sealed metallic enclosure located in the bottom of the package. This enclosure houses the N+1 fully redundant BPSs. Install these power supplies from the front of the server after removing the front bezel. Figure 1-4 Right-Front View PCI-X cards Front Panel Display Board PCI Power Supplies Cell Boards B Bulk Power Supplies Access the PCI-X card section, located toward the rear, by removing the top cover. The PCI card bulkhead connectors are located at the rear top. 16 HP Integrity rx7640 Server and HP 9000 rp7440 Server Overview

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
The server has the following dimensions:
•
Depth: Defined by cable management constraints to fit into standard 36-inch deep rack:
25.5 inches from front rack column to PCI connector surface
26.7 inches from front rack column to MP Core I/O connector surface
30 inches overall package dimension, including 2.7 inches protruding in front of the front
rack columns.
•
Width: 44.45 cm (17.5 inches), constrained by EIA standard 19 inch racks.
•
Height: 10U – 0.54 cm = 43.91 cm (17.287 inches). This is the appropriate height for a product
that consumes 10U of rack height while allowing adequate clearance between products
directly above and below this product. Fitting four server units per 2 m rack and upgrade
of current 10U height products in the future are the main height constraints.
The mass storage section located in the front enables access to the 3.5-inch hard drives without
removal of the bezel. This is especially helpful when the system is mounted in the lowest position
in a rack. The mass storage bay also accommodates one 5.25-inch removable media device. The
front panel display board, containing LEDs and the system power switch, is located directly
above the 5.25-inch removable media bay.
Below the mass storage section and behind the removable front bezel are two, N+1 PCI-X power
supplies.
The bulk power supply section is partitioned by a sealed metallic enclosure located in the bottom
of the package. This enclosure houses the N+1 fully redundant BPSs. Install these power supplies
from the front of the server after removing the front bezel.
Figure 1-4 Right-Front View
B
PCI Power
Supplies
PCI-X cards
Cell Boards
Bulk Power
Supplies
Front Panel
Display Board
Access the PCI-X card section, located toward the rear, by removing the top cover.
The PCI card bulkhead connectors are located at the rear top.
16
HP Integrity rx7640 Server and HP 9000 rp7440 Server Overview