HP t530 Administrator Guide 5 - Page 70
Restoring a client profile from a USB flash drive, VNC Shadowing, the HP ThinPro, save
View all HP t530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
3. Select the HP ThinPro configuration, and then select Next. 4. Select save the configuration, and then select Next. 5. Select on a USB key, and then select Next. 6. Select the USB flash drive. 7. Select Browse. 8. Navigate to the desired location on the USB flash drive and assign a file name to the profile. 9. Select Save. 10. Select Finish. Restoring a client profile from a USB flash drive To restore a client profile from a USB flash drive: 1. Insert the USB flash drive containing the profile into a USB port on the target thin client. 2. Select Management > ThinState in Control Panel. 3. Select the HP ThinPro configuration, and then select Next. 4. Select restore a configuration, and then select Next. 5. Select on a USB key, and then select Next. 6. Select the USB key. 7. Select Browse. 8. Double-click the desired configuration file on the USB key. 9. Select Finish. VNC Shadowing Virtual Network Computing (VNC) is a remote desktop protocol that allows you to see the desktop of a remote computer and control it with your local mouse and keyboard. To increase security, HP recommends leaving VNC disabled unless it is needed for remote diagnosis. Then, disable VNC when remote access to the thin client is no longer necessary. To access the VNC Shadow tool: ▲ Select Manageability and then select VNC Shadow in Control Panel. NOTE: You must restart the thin client before any changes to the VNC Shadowing options will take effect. The following table describes the options available in the VNC Shadow tool. Option Enable VNC Shadow VNC Read Only VNC Use Password Show "Stop Shadowing" Button Description Enables VNC Shadowing. Makes the VNC session read-only. Makes a password required when accessing the thin client using VNC. Select Set Password to set the password. If enabled, a Stop Shadowing button shows in the top left corner of the remote system. It stops VNC shadowing when pressed. 58 Chapter 9 Control Panel