HP t5745 Hardware Reference Guide HP t5740/t5745 Thin Clients - Page 25

Installing the USB Device, Removing and Replacing the Battery, WARNING - review

Get HP t5745 - Thin Client PDF manuals and user guides View all HP t5745 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Installing the USB Device Before beginning the replacement process, review General Hardware Installation Sequence on page 12 for procedures you should follow before and after installing or replacing hardware. ▲ Insert the USB device into the USB port in the secure USB compartment. See the following illustration for the location of the ports in the secure USB compartment. Figure 2-7 USB ports in the secure USB compartment Removing and Replacing the Battery Before beginning the replacement process, review General Hardware Installation Sequence on page 12 for procedures you should follow before and after installing or replacing hardware. WARNING! You must remove the right side panel to access the battery. Before removing the side access panel, ensure that the thin client is turned off and the power cord is disconnected from the electrical outlet. To remove and replace the battery: 1. Locate the battery on the system board. ENWW Installing Thin Client Options 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
Installing the USB Device
Before beginning the replacement process, review
General Hardware Installation Sequence
on page
12
for procedures you should follow before and after installing or replacing hardware.
▲
Insert the USB device into the USB port in the secure USB compartment. See the following
illustration for the location of the ports in the secure USB compartment.
Figure 2-7
USB ports in the secure USB compartment
Removing and Replacing the Battery
Before beginning the replacement process, review
General Hardware Installation Sequence
on page
12
for procedures you should follow before and after installing or replacing hardware.
WARNING!
You must remove the right side panel to access the battery. Before removing the side
access panel, ensure that the thin client is turned off and the power cord is disconnected from the
electrical outlet.
To remove and replace the battery:
1.
Locate the battery on the system board.
ENWW
Installing Thin Client Options
19