Hitachi CM751 User Manual - Page 9

Paae 9 POWER

Get Hitachi CM751 - SuperScan 751 - 19inch CRT Display PDF manuals and user guides
UPC - 050585657885
View all Hitachi CM751 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

l Use a signal cable with the D-Sub Mini 15pin Connector. 3 l If the graphics board supplies more than one type of sync. signal, the sync. signal type will be automatically selected by the monitor, with the priority shown in the following table. 4. Power On Turn on the Power Switch of the monitor first, then the computer. Refer to Paae 9 "POWER ON/OFF" NOTICE : n After turning OFF the switch, wait at least 5 seconds to restart the monitor. Otherwise the monitor may operate unusually. n If the picture doesn't appear, turn OFF the power switch, make sure of the following and wait at least 30 seconds to restart the monitor. Make sure the power switch of the computer, power cord connection, signal cable connection and the input sync. signal are right. W If the colour is impure on the screen after turning ON the monitor, wait for about 10 minutes and press the DEGAUSS button.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
l
Use a signal cable with the D-Sub Mini
15pin
Connector.
3
l
If the graphics board supplies more than one type of sync. signal, the sync.
signal type will be automatically selected by the monitor, with the priority
shown in the following table.
4. Power On
Turn on the Power Switch of the monitor first, then the computer.
Refer to
Paae 9 “POWER
ON/OFF”
NOTICE :
n
After turning OFF the switch, wait at least 5 seconds to restart the monitor.
Otherwise the
monitor may operate unusually.
n
If the picture doesn’t appear, turn OFF the power switch, make sure of the following and wait
at least 30 seconds to restart the monitor.
Make sure the power switch of the computer, power cord connection, signal cable
connection and the input sync. signal are right.
W
If the
colour
is impure on the screen after turning ON the monitor, wait for about 10 minutes
and press the DEGAUSS button.