Hitachi CP-X440 User Manual - Page 16

Power on/off Power on/off WARNING ►When the power is on, a strong light is emitted. Do not look into the lens of projector. Also do not peep at the inside of projector through a hole. NOTE • Turn the power on/off in right order. Please power on the projector prior to the connected devices. Power off the projector later than the connected devices. VIDEO RGB SEARCH ASPECT AUTO BLANK MAGNIFY ON OFF FREEZE VOLUME MUTE KEYSTONE POSITION MENU ESC ENTER RESET STANDBY/ON button Power switch POWER indicator Turning on the power 1. Make sure that the power cord is firmly and correctly connected to the projector and the outlet. POWER (Steady orange) 2. Remove the lens cover, and set the power switch to the ON position. The power indicator will light up in steady orange. Then wait several seconds because the buttons may not function for these several seconds. POWER (Blinking in green) POWER (Steady green) 3. Press the STANDBY/ON button on the projector or the remote control. The projector lamp will light up and the POWER indicator will begin blinking in green. When the power is completely on, the indicator will stop blinking and light in green. To display the picture, select an input signal according to the section "Selecting an input signal" (17). Turning off the power 1. Press the STANDBY/ON button on the projector or the remote control. The message "Power off?" will appear on the screen for approximately 5 seconds. 2. Press the STANDBY/ON button on the projector or the remote control again while the message appears. The projector lamp will go off, and the POWER indicator will begin blinking in orange. Power off? POWER (Blinking in orange) POWER Then the POWER indicator will stop blinking and light in steady orange when the lamp cooling is complete. (Steady orange) 3. Make sure that the power indicator lights in steady orange, and set the power switch to the OFF position. The POWER indicator will go off. Attach the lens cover. 16