Hitachi CP-X440 User Manual - Page 4

Part names - parts

Get Hitachi CP-X440 PDF manuals and user guides View all Hitachi CP-X440 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

Part names Part names Projector Zoom knob (18) Focus ring (18) Vent (6) Lens (16) Front-Right side Lamp cover (39) (Lamp unit is inside.) Remote sensor (15) Elevator button (8) Elevator foot (8) Filter cover (9,40) (Air filter and intake vent are inside.) Control buttons (5) (See the following page.) Ports (See below.) Bottom side AC inlet (13) Power switch (16) Rear-Left side Speaker Elevator button (8) Elevator foot (8) Vent (6) COMPONENT VIDEO ports (12) Y CB/PB CR/PR AUDIO 2 L/R port (12) VIDEO port (12) S-VIDEO port (12) Restart switch (*) (46) RGB IN1 port (11) RGB IN1 RGB IN2 AUDIO 1-IN AUDIO-OUT RGB IN2 port (11) COMPONENT VIDEO RGB OUT CR/PR CB/PB Y CONTROL AUDIO-OUT port (11) AUDIO 1-IN port (11) R-AUDIO 2-L VIDEO S-VIDEO Ports CONTROL port (11) RGB OUT port (11) NOTE (*) About Restart switch: This projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar, and before turning on again, make the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
4
Y
VIDEO
RGB IN1
RGB IN2
RGB OUT
CONTROL
AUDIO 1-IN
S-VIDEO
COMPONENT VIDEO
C
B
/P
B
C
R
/P
R
R-AUDIO 2-L
AUDIO-OUT
Part names
Lens (
16
)
Filter cover (
9,40
)
(Air filter and intake vent
are inside.)
Elevator button (
8
)
Elevator foot (
8
)
Remote sensor (
15
)
Zoom knob (
18
)
Focus ring (
18
)
Vent (
6
)
AC inlet (
13
)
Power switch (
16
)
Elevator button (
8
)
COMPONENT
VIDEO ports (
12
)
Y
C
B
/P
B
C
R
/P
R
S-VIDEO port (
12
)
VIDEO port (
12
)
CONTROL port (
11
)
Part names
Projector
Lamp cover (
39
)
(Lamp unit is inside.)
Elevator foot (
8
)
B
Front-Right side
Rear-Left side
Control buttons (
5
)
(See the following page.)
Ports (See below.)
Vent (
6
)
AUDIO-OUT port (
11
)
Ports
AUDIO 1-IN port (
11
)
AUDIO 2 L/R port (
12
)
RGB IN1 port (
11
)
RGB IN2 port (
11
)
NOTE
(*) About Restart switch:
This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
Speaker
Restart switch (*) (
46
)
RGB OUT port (
11
)