Hitachi CPX265 Network Functions - Page 28

Projector management via SNMP Projector management via SNMP When SNMP is enabled, the projector is able to send Failure/Warning Alerts to a specified PC. NOTE • It is recommended that SNMP functions be carried out by a network administrator. • SNMP management software must be installed on the computer to monitor the projector via SNMP. SNMP settings (9) Configure the following items via a web browser to use SNMP. Example: If the IP address of the projector is set to 192.168.1.10: 1) Enter [https://192.168.1.10] into the address bar of the web browser. 2) Enter the Administrator ID and Password and click [Logon]. 3) Click [Port Settings] on the main menu. 4) Click the [Enable] check box to open the SNMP Port. Set the IP address to send the SNMP Trap to when a Failure/Warning occurs. NOTE • A Network Restart is required after the SNMP Trap configuration settings have been changed. Click [Network Restart] and configure the following items. 5) Click [Security Settings] on the main menu. 6) Click [SNMP] and set the Community Name on the screen that is displayed. NOTE • A Network Restart is required after the Community Name has been changed. • Click [Network Restart] and configure the following items. 7) Configure the settings for Trap transmission of Failures/Warnings. Click [Alert Settings] on the main menu and select the Failure/Warning item to be configured. 8) Click the [Enable] check box to send out the SNMP trap for Failures/Warnings. Clear the [Enable] check box when SNMP trap transmission is not required. 9) Click the [Apply] button to save the settings. 28