Hitachi ED-X3400 User Manual - Page 4
Part names - projector lamp
View all Hitachi ED-X3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Part names Part names Projector Zoom knob (18) Focus ring (18) Vent (6) Lens cover (16) (Slide door) Lens (16) Lamp cover (Lamp unit is inside.) (38) Front-Right side Remote sensor (15) Speaker Elevator button (8) Elevator foot (8) Filter cover (40) (Air filter and intake vent are inside.) Control buttons (See the following page.) (5) Ports (See below.) Bottom side AUDIO OUT port (11) Rear-Left side AUDIO IN1 port (11) S-VIDEO port (12) COMPONENT VIDEO ports (12) Y CB/PB CR/PR VIDEO port (12) AUDIO IN2 port (11) AUDIO IN1 Y CB/PB AUDIO OUT VIDEO AUDIO IN2 CR/PR S-VIDEO USB COMPONENT VIDEO RGB IN1 RGB IN2 CONTROL Ports RGB OUT USB port (21) Power switch (16) AC inlet (13) Elevator button (8) Elevator foot (8) Vent (6) Restart switch (*) (46) RGB IN1 port (11) RGB IN2 port (11) RGB OUT port (11) CONTROL port (11) Kensington lock slot NOTE (*) About Restart switch: This Projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar and before turning on again, make the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances. 4