HoMedics BPA-201 Downloadable Instruction Book - Page 15

8. Do not disassemble the monitor or cuff. If in need of repair, refer to the warranty section of this manual. 9. Do not subject the monitor to extreme shocks (do not drop on floor). 10. Do not inflate the cuff unless wrapped around your arm. 11. Do not wrap the cuff around body parts other than your arm. 12. Do not drop or insert any object into any ­o­ pening or hose. 13. To avoid accidental strangulation keep this product away from children. Do not drape tube around neck. 14. This monitor may not meet its performance specifications if stored or used outside of these temperature and humidity ranges: • Storage Environment • Operating Environment Temperature: Temperature: - 4°F~158°F (-20°C~70°C) 50°F~104°F (10°C ~40°C) Humidity: Humidity: less than 90% RH 15% ~ 90% RH 27 POTENTIAL FOR ELECTROMAGNETIC INTERFERENCE To avoid inaccurate results caused by electromagnetic interference between electrical and electronic equipment, do not use the device near a cell phone or microwave oven. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. 28