HoMedics BPA-201 Downloadable Instruction Book - Page 16

TROUBLESHOOTING If any abnormality arises during use, please check the following points SYMPTOMS POSSIBLE CAUSES CORRECTION Unit does not turn on when the START/ STOP button is pushed. Batteries have run down. Battery polarities have been positioned incorrectly. Replace them with four new AA alkaline batteries. Re-insert the batteries in the correct positions. EE measurement error Cuff has been placed Wrap the cuff properly symbol shown on dis- incorrectly. so that it is positioned play or the blood pres- correctly. sure value is displayed excessively low (or high). Did you talk or move Measure again. Keep during measurement? arm steady during Shaking of the arm with measurement. the cuff on. E1 error symbol shown Air circuit abnormality. on display Cuff tube may not be plugged into monitor correctly. Check cuff connection. Measure again. E2 error symbol shown Inflation pressure Switch the unit off, then on display exceeding 300 mmHg. measure again. E3 error symbol shown Error determining on display measurement data. Measure again. Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance should you disassemble or attempt to repair the unit by yourself. Contact information for HoMedics Consumer Relations Department can be found on the warranty page. 29 SPECIFICATIONS Power Source: Four 1.5V DC (AA) batteries or 6V DC AC adapter Measurement Method: Oscillometric Measurement Range: Accuracy: Pressure: 40~280 millimeters mercury (mmHg) Pulse: 40~199 beats/minute Pressure: ±3 mmHg Pulse: ±5% of reading Pressure Sensor: Semi-conductor Inflation: Pump driven Deflation: Automatic Pressure release valve Memory Capacity: 60 memories for each User (120 total) Auto-shut-off: Operation Environment: Storage Environment: Weight: Arm Circumference: Dimensions: 1 minute after last button operation Temperature: 50°F~104°F (10°C ~40°C) Humidity: 15% ~ 90% RH Temperature: -4°F~158°F (-20°C~70°C) Humidity: Less Than 90% RH 0.86 lbs (390 g) (without batteries) Standard size cuff: 9"-13" (23-33 cm) Large size cuff:13"-17" (33-43 cm) 4.5"(L) x 5.9"(W) x 3"(H) 114mm(L) x 150mm(W) x 76mm(H) Accessories: 6V DC AC adapter, arm cuffs with tube, pouch Internally Powered equipment Type BF Equipment IPx0-No special protection against the ingress of water Not suitable for use in presence of flammable anesthetic mixture with air, oxygen or nitrous oxide. Continuous operation with short-time loading. Note: These specifications are subject to change without notice. 30