HoMedics BPA-201 Downloadable Instruction Book - Page 7

INSTALLING BATTERIES 1. Extend the tray so that the battery cover is fully exposed. 2. Press down on latch and lift the battery cover to open the battery compartment. 3. Install or replace 4 "AA­" sized batteries in the battery compartment according to the indications inside the compartment. 4. Close the battery cover by pushing in the top end of the battery door. Battery Cover Slide-Out Tray Replace the batteries if: 1. The weak battery symbol appears on the display. 2. Nothing appears on the display when the power is switched on. As the supplied batteries are for test only, they may be discharged earlier than batteries you buy in stores. Replace all batteries at one time (as simultaneous set). Use only 1.5V AA­ alkaline batteries. Remove batteries when unit is not in use for extended periods of time. Date and time will need to be reset if batteries are removed or replaced. Clean contacts on battery and in battery compartment with a soft dry cloth each time you install batteries. Note: Batteries are hazardous waste. Do not dispose of them together with the household garbage. 11 USING THE AC ADAPTER Note:  • Please unload the batteries when operating with an AC adapter for an extended period of time. Leaving the batteries in the compartment for a long time may cause leakage, which may lead to damage to the unit. • No batteries are needed when operating with an AC adapter. • Date and time will need to be reset if AC adapter is unplugged and unit is without batteries. 1. Connect the AC adapter with the AC adapter jack in the back of the unit as shown below. 2. Please use only the AC adapter included with this monitor. AC Adapter Input: 100-240V~0.2A 50/60Hz Output: 6V DC 1A 6W Max Connect AC Adapter here 12