HoMedics UHE-CMTF91 User Manual - Page 6

TO FILL WITH A PITCHER TO FILL AT THE FAUCET 1. Before filling with water 2. Remove the tank for the first time, remove cover. 1 demineralization cartridge from the packaging and soak in water for 10 minutes. 1. Before filling with water 2. Remove the tank for the first time, remove cover and water 1 demineralization tank. cartridge from the packaging and soak in water for 10 minutes. MAX MAX 3. Fill with clean, cool water or distilled water (if in area with hard water) until the water level reaches the MAX fill line. DO NOT fill with warm or hot water. CAUTION: Never add essential oils or other additives to the water tank or water reservoir. Refer to the section on how to properly use essential oils with this humidifier. 3. Use 2 hands to carry the water tank. Fill with clean, cool water or distilled water (if in area with hard water) until the water level reaches the MAX fill line. DO NOT fill with warm or hot water. CAUTION: Never add essential oils or other additives to the water tank or water reservoir. Refer to the section on how to properly use essential oils with this humidifier. 4. Add the soaked demineralization cartridge to the water tank. 5. Replace the tank cover. 4. Add the soaked demineralization cartridge to the water tank. 5. 5. Reassemble making sure all parts are firmly seated. ABOUT WHITE DUST Use of high mineral content hard water may cause a white mineral residue to accumulate on surfaces in the room near the humidifier. The mineral residue is commonly called "white dust." The higher the mineral content (or, the harder your water is), the greater the potential for white dust. The white dust is not caused by a defect in the humidifier. It is caused only by minerals suspended in the water. 6