HoMedics UHE-CMTF91 User Manual - Page 7
How To Operate
View all HoMedics UHE-CMTF91 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
HOW TO OPERATE POWER BUTTON Turns humidifier on/off MIST OUTPUT Mist adjusts from the lowest output (1) to the highest output (3). To increase the mist output, press the mist output button. The corresponding mist level will be lit on the display. Continue to press the mist output button to cycle through the mist output settings. Use the 360-degree rotating mist nozzle to adjust the mist output direction. Do not point the mist nozzle toward walls or furniture. NIGHT-LIGHT/DISPLAY LIGHTS Press the night-light button once to turn on the night-light. The light at the bottom of the humidifier will turn on. Press the button a second time to leave the night-light on, but turn off display panel. Press the button a third time to turn off the night-light and display panel. Press the night-light button a fourth time to turn the display lights on. PROGRAMMING THE HUMIDITY LEVEL The default humidistat setting is CO (continuous on). The programmable humidistat can be set in 5% increments, from 35% to 55% humidity. The humidity level will increase by 5% each time the button is pressed and will be displayed on screen. NOTE: Humidifier will turn off when the set humidity level is reached. Humidifier will turn on when the humidity level drops 5% below the set humidity level. NOTE: To eliminate any programmed humidistat setting, continue to press the programmable humidistat button until you reach CO, one level above 55%. TIMER Press the timer button until the desired auto-shutoff timer setting is displayed. The timer button will cycle through the following settings: 4 hours, 8 hours, 12 hours, and 0 hours. To cancel the timer at any time, press the timer button until 0 hours is displayed. NOTE: Always be sure the humidifier has a full tank of water prior to using the timer setting. CLEAN REMINDER The clean LED will illuminate red indicating it is time to clean the transducer/ultrasonic membrane. After cleaning, press and hold the clean indicator/reset button until the red LED turns off (Cleaning instructions are in the HOW TO CLEAN AND CARE section). 7