Honeywell 2054 Operation Manual - Page 5

Additional Features: Removable Shelves Shelves Removable Shelf (Model 2054 only) To remove the shelf, simply lift it up and tilt it on a sufficient angle to provide clearance for removal. Adjustable & Removable Shelves (Model 2084 only) These models are designed with 5 position adjustable shelves to allow greater flexibility and further accommodate your particular security storage needs. To Install: Your Shelf and Shelf Support Clips have been shipped inside your safe and wrapped for protection from damage during shipping. SUPPORT GUIDES 1. Remove Shelf and (4) Shelf Support Clips from protective wrapping. 2. Determine the desired position of your shelf and note the corresponding Support Guide Slots (2 on each side of interior walls) that are best suited to support the shelf in that position. 3. Install the (4) Shelf Support Clips in the same position on all four support guides. 4. Install shelf into position by placing it inside the safe (tilting if necessary) at a point above the desired position. 5. Once inside, lower it into position until resting on Shelf Support Clips. To change the position of the shelf: Simply remove the shelf and reposition the (4) shelf support clips by sliding them up and out of the support slots and reinstalling them into the new positions. Then reinstall the shelf as described above. Important: REMOVING SHELF If you remove the shelf, it is strongly recommended that you DO NOT DISCARD it. You may lay the shelf flat in the bottom of the safe to assure full flexibility in the future. Home and Office Security Safes 3