Honeywell 2054 Operation Manual - Page 7
Home and Office Security Safes - safe model
UPC - 016247205405
View all Honeywell 2054 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Additional Features: Bolt-Down Kit Models 2054 (only) Installation Procedure 1. Choose a mounting location that is easily accessible from both above and below. 2. Carefully position the template on the location that you want to mount the safe. 3. Create the guide marks by pressing a sharp tool through the circles at the four corners of the template and into the mounting location. 4. Drill a hole (the diameter of the break-off bolt shaft) through each guide mark. Important: DON'T DRILL SAFE Do not drill into the feet, bottom or any other part of safe! Doing so will ELIMINATE THE FIRE PROTECTION that has been designed into your safe and invalidate all stated warranties. 5. Before attaching the safe, you should check carefully that the 4 holes you have drilled match up precisely with the holes that have been pre-drilled in the bottom of the safe. Note: On certain models, It may be necessary to remove the rubber foot pads that are screwed into the bolt-down holes at the factory. 6. Once you have confirmed that the holes are aligned and in the location you desire, install the break-off bolts and washers from underneath the mounting location (through the furniture or shelf), and into the pre-drilled holes in the safe. 7. Turn bolts until the screw heads break off. Home and Office Security Safes 5