Honeywell 2070A Operating Guide - Page 4

Opening Safe For The First Time Opening Your Safe for the First Time Using the Pre-set Factory Code. Green Red Yellow Light Light Light Batteries have been pre- installed at the factory. Using the factory pre-set Passcode 159A, open the safe as follows: 1. Enter the three digit number 159 on the keypad followed by the letter A. If entered correctly, the green LED will light and the lock will click. 2. Pull the handle open within 5 seconds and open the door. 1 4 7 A 23 56 1 8 9 4 7 0 B A 2 5 8 0 3 6 9 B DIGITAL NIC ELECTRO SAFE Important: Anti-Theft safe If no action is taken, the safe will automatically relock in 5 seconds and the code will need to be re-entered. Red 3. A red LED indicates that the Passcode was entered Light incorrectly. Re-enter the code and try again. Security Lockout: The safe is designed to lock out the keypad if the wrong Passcode multiple times. • After the 3rd error: 20 second lock-out. (waiting period) • 4-6 errors: 5 minute lock-out. is en147Ate25r80ed369B • 7+ errors: 1 hour lock-out. If you have forgotten the Passcode, entry can be made using the Emergency Override Key. (See page 7). Closing Your Safe 1. Make sure nothing inside the safe is obstructing the door from completely closing. 2. Close the safe door and press the handle into the locked position. Important: This safe is equipped with an interior light. The control switch is located on the inside door panel. When closing the safe it is important that the light switch be turned to the off position. Failure to do so will drain the batteries of power and the safe will not open when the digital key pad is used. 2