Honeywell 2070A Operating Guide - Page 8

Programming a Personal Passcode For security reasons, it is very important that you program your own personal Passcode into the digital lock. The factory Passcode 159A should be changed immediately. Programming Your Personal Passcode 1. Using the factory assigned Passcode (159A), open the safe. (See page 2). 2. Locate and then press and release the small red memory button located inside the safe on the edge of the lock cover. The keypad will beep twice and the yellow LED will light. Memory Button 3. Select a Passcode using 3 to 8 numbers (no letters) and enter it on the keypad. 4. After entering the numbers, press the B key. The keypad will again beep twice and the yellow LED will light. This will complete the programming of your personal Passcode. Leave the door open and proceed to Testing Your New Yellow Light Passcode. Testing Your New Passcode 1. With the door in the open position, push the lock handle into the closed position. In about 3 seconds, the safe will automatically lock. 2. Enter your new personal Passcode onto the keypad followed by the letter A and the digital lock should click open. Example: A 1 4 7 A 2 5 8 0 3 6 9 B Important: Your new Passcode will always consist of your selected number code followed by the letter A. 3. Pull the handle and open the safe. 4. If the new Passcode does not unlock the safe, then repeat the steps to program your personal Passcode and retest. Once programming is completed, write your personal Passcode down and store it in a safe and secure place away from the safe. The factory pre-set Passcode will no longer open your safe. 6