Honeywell 3800ISR050-0F00E User Manual - Page 152
Replacing the Interface Cable, Cable, Release
View all Honeywell 3800ISR050-0F00E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Replacing the Interface Cable The standard interface cable is attached to the scanner with an 10-pin modular connector. When properly seated, the connector is held in the 3800i/3800r scanner's handle by a flexible retention tab. The interface cable is designed to be field replaceable. • Order replacement cables from Hand Held Products or from an authorized distributor. • When ordering a replacement cable, specify the cable part number of the original interface cable. To Replace the 3800r Interface Cable: 1. Turn the power to the host system OFF. 2. Disconnect the scanner's cable from the terminal or computer. 3. Locate the small hole on the side of the scanner's handle (3800i/3800r). This is the cable release. 4. Straighten one end of a paper clip. 5. Insert the end of the paper clip into the small hole and press in. This depresses the retention tab, releasing the connector. Pull the connector out while maintaining pressure on the paper clip, then remove the paper clip. 6. Replace with the new cable. Insert the connector into the opening and press firmly. The connector is keyed to go in only one way, and will click into place. Cable Release 13 - 2 3800i/3800r User's Guide