Honeywell 4286 User Guide - Page 26
Using the Relay Command Mode - telephone voice module
UPC - 781410055452
View all Honeywell 4286 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Using the Relay Command Mode General Information Your system may be set up so that certain lights or other devices can be turned on or off from a telephone keypad. If your system has the # 7 0 Voice Response Relay Command Mode, follow the procedure below. For systems NOT having the # 7 0 interactive mode, refer to the User Guide for the system or ask your installer for specific information on the relay command feature, if available. Systems not having the # 7 0 mode, but equipped with relay output devices, may provide no phone feedback when a relay command is entered via the phone. Using the Voice Response # 70 Relay Command Mode Ask your installer if this mode is available in your system. If it is, place a check in this box as a reminder. To activate devices via the telephone, access the security system using your 2digit phone access code. When the system acknowledges the access, enter your 4-digit system security code + [#] + 70. The following phone prompts will begin: Voice Prompt: "ENTER DEVICE CODE NOW" Enter the 2-digit number of the device to be activated. Voice Prompt: "(Voice Descriptor), DEVICE ## ON/OFF." "For Voice Descriptor ON, ENTER 2, for Voice Descriptor OFF, ENTER 1." "##" represents the 2-digit device number, and (Voice Descriptor) is the relay phone descriptor programmed by the installer for that device (for example, HALL LIGHT). Voice Prompt: "(Voice Descriptor), DEVICE ## ON/OFF. TO EXIT, ENTER 00 NOW" Enter 00 to exit, or enter the next device number to be programmed. The current on/off state of that device will be annunciated as described above. Alternatively, if 6 seconds elapses with no key depression, the phone module will annunciate the "ENTER DEVICE CODE NOW" message. 22