Honeywell 4286 User Guide - Page 29
Programming Speaker Output Mode
UPC - 781410055452
View all Honeywell 4286 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Programming Speaker Output Mode About the Speaker Output Pressing "G G" on the monitored keypad will trigger a status announcement from the speaker output (except if you have selected the MUTE speaker control menu selection). User command confirmation for Entry/Exit, Alarm, and other warnings can also be provided. If your installer connected an external speaker to the control you must program the speaker output. To do this: 1. Obtain phone access with phone code/user code, as required. Be sure to wait for arming status announcement to end before continuing. 2. Press # 97 on phone keypad. A menu will be announced, which is shown below. Press "1" or "0" in response to the prompt. The prompt will be repeated after several seconds without a key being pressed in response. To exit speaker control programming, complete all required entries or hang up the phone. If the phone is hung up before the Phone Module announces "Exiting", then any changes made will be lost. If a key other than "1" or "0" is pressed, a buzzer sound will be generated in the phone handset, and the menu request will be repeated. Voice Menu for Programming Speaker Output Mode: SPEAKER CONTROL CATEGORIES MUTE: 1 = Yes, 0 = No ALL ON: 1 = Yes, 0 = No DESCRIPTION Disables all possible speaker output including those sounds listed below. It will also disable the status announcement provided when the "G" key is pressed twice on the monitored keypad. It will not mute certain panel synthesized phone commands that the control directs to the speaker, such as transmitter learn mode speaker output. If "1" is pressed, the system will announce "Exiting," and exit speaker output mode. Enables all sound categories. If "1" is pressed, the system will announce "Exiting", and exit speaker output mode. 25