Honeywell HY-047B User Guide - Page 3

ASSEMBLY INSTRUCTIONS (cont'd) B. Base Assembly Fig. 7 •Align the two portions of the circular base and snap together by gently pushing the 4 round extrusions (Fig. 7, Item A) into the adjacent circles of the connecting piece (Fig. 7, Item B) C. Securing the Pedestal to the Base A B • Line up the arrow marked as on the pedestal with the arrow marked as on the base. (Fig. 8) Align the 3 round extrusions with the 3 holes in the base. Base Assembly Fig. 8 • Secure the base assembly to the pedestal by inserting and tightening the 3 thumb screws in the 3 holes located on the bottom of the base. (Fig. 9) D. Securing the Tower Fan to the Pedestal • Carefully turn the fan on its side. Place the power cord through the center of the pedestal and base assembly. Fig. 9 • Align the pedestal arrow marked as with the tower fan arrow marked as . Firmly hold the base steady and rotate the pedestal assembly clockwise to lock the tower fan in place. (Fig. 10) • Secure the pedestal to the tower fan by inserting and tightening 1 thumb screw in the opening located near the top rear of the pedestal assembly. (Fig. 11) Fig. 10 E. Securing the Cord to the Base • With the fan still on its side, locate the cord holding bracket on the bottom of the base. • Gently pull any slack out of the power cord, place the power cord securely in the holding bracket and secure the power cord bracket over the power cord. (Fig. 12) • Return the tower fan to its upright position. Fig. 11 Note: Do not operate the tower fan unless it is in its proper, upright position. Note: Only one thumb screw is needed for the low height option. Do not discard the additional screws as they will be needed for Tall Height Option F. Placing the Remote Control in the Storage Area Fig. 12 • Locate the remote control that has been provided with the tower fan. Make sure that the remote control is not thrown out with the packing materials. • Install batteries into the remote control battery compartment (see Battery Installation/Replacement Instructions). • Place the remote control in the recessed remote holder located Fig. 13 on the top of the fan. (Fig. 13)