Hoover F7458-900 Product Manual - Page 16

Cleaning upholstery Read "Before You Begin Cleaning" instructions on page 10. Be sure to check the cleaning code on your upholstery. Use your cleaner only on upholstery marked "W" or "W/S". Attach hose and solution tube as instructed in Figs. 4.1 to 4.2. Place handle in upright position. Agitator brushes will not rotate while handle is in upright position. Fill Clean Water Tank according to instructions for Figs. 2.9 to 2.11. Fill detergent container with HOOVER® detergent according to instructions for Fig. 2.10. Do not use hard floor cleaning solution when cleaning upholstery. Attach tool to end of hose. Do not point tools toward people or pets. Dry hands and plug cleaner into a properly grounded outlet. IMPORTANT rinse is not available during tool use. The hose will only dispense water mixed with detergent. Set Rinse Setting switch to WASH. Turn cleaner ON. 4.11 Gently press the tool onto the fabric. Press the trigger and slowly pull the nozzle over the fabric. Overlap strokes by 1/2 inch to help prevent streaking. 4.11 4.12 Make additional strokes without pressing the trigger to remove more moisture. To clean in corners or creases, lift the tool one half inch from the fabric and press the solution trigger. Vacuum up the solution with the tool without pressing the trigger. 4.12 For heavily soiled areas, it may be necessary to repeat the cleaning process. Make crisscrossing strokes to the original pattern; overlap each pass. Make no more than 2 passes with the solution over any one area to prevent over-wetting and damage to fabric. If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again. Empty Dirty Water Tank when the motor sound becomes higher pitched and there is a loss in suction (see "Automatic Shut-Off", Fig. 2.17). When finished cleaning, follow "After Cleaning" instructions on page 12 and "After Using Tool" instructions on page 14. Actual model may vary from images shown. 16