Hoover F8100900 Product Manual - Page 13

HOW TO OPERATE 3. HOW TO OPERATE Tank Status Indicators The computerized controls will perform a self diag- detergents might not be recognized by the sen- notics test the first time the machine is powered sor. The cleaner will continue to operate properly up after being plugged in. This process takes 5 seconds during which all of the lights on the control panel will flash. This is normal. The appropriate tank status light will blink when even though the light has been activated. The tank status light representing the Dirty Water Recovery Tank will blink when the tank is full and needs to be emptied. In this state, the the Clean Water or Detergent Tank is empty. cleaner will no longer dispense liquid so that the In some circumstances, "soft water" or certain carpet does not become over-saturated. Emptying the Dirty Water Recovery Tank Turn carpet cleaner off and unplug from outlet. Do not use without float in place. If broken or dislodged, take to an authorized Hoover® dealer for repair. 3.8 3.9 3.10 3.11 A 3.7 3.12 B 3.8 Lower cleaner han- 3.9 Grasp handle of 3.10 Set tank on coun- 3.11 Dump dirty water 3.12 Secure lid to tank dle to the floor. Dirty Water Recovery ter-top or table and in sink or toilet. Rinse and place tank back Tank and pull straight remove lid by pushing out Dirty Recovery Tank into cleaner. up. button (A) and pivoting and be sure to remove lint the lid up and away from tank. and dirt from screen (B). 12