Hoover Power Scrub Deluxe Product Manual - Page 28
Cleaning Carpeted Stairs
View all Hoover Power Scrub Deluxe manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
After Using Tool 1. Drain suction hose by turning cleaner ON and 37 holding nozzle up for several minutes. Do not press trigger. ! CAUTION ! Always turn off appliance before connecting or disconnecting hose. 2. Disconnect hose and solution tube from cleaner. 3. Drain solution tube by placing round end in sink and raising the trigger end at the hose nozzle above your head (Fig. 37). Press the trigger to release air and fluid.. 4. Replace Hose and tools in the Mesh Storage Bag. CLEANING CARPETED STAIRS 38 1. Read "Before You Begin Cleaning" instructions on page 10. 2. Attach hose and solution tube as instructed (Pg. 13). 3. Place handle in upright position. SpinScrub brushes will not rotate while handle is in upright position. 4. Fill Clean Water Tank according to instructions. 39 5. Fill Solution Tank with HOOVER® solution according to instructions. 6. Attach tool to end of hose. ! CAUTION ! Use extra care when cleaning on stairs. To avoid personal injury or damage, and to prevent the cleaner from falling, always place cleaner at bottom of stairs or on floor. Do not place cleaner on stairs or furniture, as it may result in injury or damage. 7. Dry hands and plug cleaner into a properly grounded outlet. 8. Set Wash/ Rinse Selection to WASH. Turn cleaner ON. 9. Pre-spray the carpeted stair by holding the tool about one inch above the carpet and push it forward while pressing the trigger (equals one wet stroke) (Fig. 38). 10. Position tool against the riser and slightly press it into carpet pile. Press the trigger and pull the tool slowly over the carpet (second wet stroke). Release trigger at end of stroke. 11. Lift tool, and position it against riser. Pull tool slowly over carpet without pressing trigger (dry stroke) (Fig. 39). 12. Overlap strokes by 1/2 inch to help prevent streaking. 13. It is best to alternate wet and dry strokes as described above. End with more dry strokes to aid in faster drying of carpet. 14. To avoid saturating carpet, do not use more than 4 wet strokes over any one area. Always end with dry strokes. 15. If additional cleaning is necessary, wait until the carpet is completely dry before using the tool again. 16. Empty Dirty Water Tank when the motor sound becomes higher pitched and there is a loss in suction (see "Automatic Shut-Off"). 17. When finished cleaning, follow "After Cleaning" and "After Using Tool" instructions. 14 Actual model may vary from images shown.