Hoover U5146-900 Owners Manual - Page 8

Maintenance

Page 8 highlights

2-15 H Extra reach hose (available at additional cost) The extra reach hose provides you with a 20 foot reach to allow easier cleaning of stairs and hard to reach places. Follow the steps below for attaching and detaching hose. 2-16 2-17 J Attach wand and tools Attach tool or wand or crevice wand (some models) to the hose (H) by pushing it firmly into hose. Attach second wand or tool to the wand in the same manner. Twist wand or tool slightly to tighten or loosen the connection. I J Push ON/OFF switch to OFF position and unplug from electrical outlet. Remove regular hose from cleaner. Align end of extra reach hose with projections (I) over slots (J) in dirt duct. Slide hose into slots (J) and twist hose to lock it into place. To detach hose, reverse procedure. Attach wands or tools to the other end of hose. 2-18 K Check bag indicator The indicator (K), will begin to show red as the filter bag fills with dirt. There are three conditions that will cause the indicator to become completely red: 1. The bag is full; change the bag. 2. Very fine materials have been picked up, clogging the bag pores; change the bag. 3. There is a blockage in the nozzle, hose, tools or at the bag opening; remove the blockage (see "Clearing blockages" section). 3. Maintenance Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness. Filter bag When to replace Check filter bag from time to time. It is recommended that you change the filter bag when dirt reaches the dotted line. If more dirt than this accumulates, your cleaner will not operate effectively. NOTE: All new carpet has loose fibers which can fill the bag quickly while vacuuming. So, if you are using the cleaner on new carpet, be sure to change the filter bag often. CAUTION: Very fine materials, such as face powder or cornstarch, may seal the filter bag and may cause it to burst even though it is partially full of dirt. When the cleaner is used to remove material of this nature, change filter bag often. Where to buy Filter bags may be purchased from your Authorized Hoover Dealer (Depot), leading retailers, Hoover Factory Service Centers or through The Hoover Company on-line at www.hoover.com. 8 What to buy To assure cleaning effectiveness, use only Genuine Hoover® Allergen Filtration Type Y disposable filter bags. It is imperative that you use only genuine HOOVER filter bags made by The Hoover Company to assure that your cleaner operates at peak performance. HOOVER bags can be identified by these trademarks -- ® Changing filter bag Disconnect cleaner from electrical outlet. 3-1 Removing bag door To change filter bag, push down at top of bag door and pull door forward. Remove door.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

3. Maintenance
What to buy
To assure cleaning effectiveness, use
only Genuine Hoover® Allergen Filtration
T
ype Y
disposable filter bags.
Changing filter bag
Disconnect cleaner from electrical
outlet.
8
2-15
Familiarize yourself with these home
maintenance tasks as proper use and
care of your cleaner will ensure contin-
ued cleaning effectiveness.
Filter bag
When to replace
Check filter bag from time to time. It is
recommended that you change the filter
bag when dirt reaches the dotted line. If
more dirt than this accumulates, your
cleaner will not operate effectively.
NOTE: All new carpet has loose fibers
which can fill the bag quickly while vac-
uuming. So, if you are using the cleaner
on new carpet, be sure to change the fil-
ter bag often.
CAUTION: Very fine materials, such
as face powder or cornstarch, may
seal the filter bag and may cause it to
burst even though it is partially full of
dirt. When the cleaner is used to
remove material of this nature,
change filter bag often.
Where to buy
Filter bags may be purchased from
your Authorized Hoover Dealer
(Depot), leading retailers, Hoover Fac-
tory Service Centers or through The
Hoover Company on-line at
www.hoover.com.
2-17
2-16
H
K
Attach wand and tools
Attach tool or wand or crevice wand (some
models) to the hose (H) by pushing it firmly
into hose.
Attach second wand or tool to the wand in
the same manner.
Twist wand or tool slightly to tighten or
loosen the connection.
Check bag indicator
The indicator (K), will begin to show red as
the filter bag fills with dirt.
There are three conditions that will cause
the indicator to become completely red:
1. The bag is full; change the bag.
2. Very fine materials have been picked
up, clogging the bag pores; change the
bag.
3. There is a blockage in the nozzle, hose,
tools or at the bag opening; remove the
blockage (see “Clearing blockages”
section).
Extra reach hose
(available at additional cost)
The extra reach hose provides you with a
20 foot reach to allow easier cleaning of
stairs and hard to reach places. Follow the
steps below for attaching and detaching
hose.
Push ON/OFF switch to OFF position
and unplug from electrical outlet.
Remove regular hose from cleaner.
Align end of extra reach hose with projec-
tions (I) over slots (J) in dirt duct.
Slide hose into slots (J) and twist hose to
lock it into place.
To detach hose, reverse procedure.
Attach wands or tools to the other end of
hose.
Removing bag door
To change filter bag, push down at top
of bag door and pull door forward.
Remove door.
I
J
J
It is imperative that you use only genuine
HOOVER filter bags made by The
Hoover Company to assure that your
cleaner operates at peak performance.
HOOVER bags can be identified by
these trademarks --
®
3-1
2-18