Hoover U6634900 Manual - Page 11

3-24 3-25 3-26 F D Replacing brush roll Removing brush roll Slide brush roll control (Fig. 2-9) to "Hard" (OFF) position. Turn cleaner over and remove bottom plate (Fig. 3-18). Lift up brush roll and slide V-belt (D) off brush roll. E C Inspecting V-belt The V-belt is designed to last for a long time and is not normally replaced. However, if V-belt is cracked, gouged or broken, now is a good time to replace it as follows. Slide flat belt off large pulley as shown in Fig. 3-19. To remove V-belt, slide back of belt over pulley (C). Then firmly pull on belt and "snap" it out. Discard used belt. Replace with Hoover belt part no. 38528034 (belt package part no. 40201200). To install new belt (with lettering on outside of belt), slide back of belt over pulley and pull front of belt toward groove (E) next to pulley. Belt will "pop" into place. Positioning belt on brush roll Before positioning belt onto brush roll, check for debris accumulation as described in Fig. 4-1. Insert brush roll through belt and position belt in groove (F) on brush roll. 3-27 H G Powered hand tool 3-29 B Agitator brush roll replacement When agitator brush roll brushes are worn, the brush roll should be replaced. Ask for HOOVER part No. 48414088. 3-28 A Installing brush roll Grasp brush roll and fit it into position by first sliding end, opposite the belt, into the rectangular slot (G) on side of cleaner. Push other side of brush roll (H) into place. Belt may fit loosely when properly installed. Reposition flat belt and bottom plate (Figs. 3-20 and 3-22). How to replace 1. Remove tool from hose and turn it so bottom faces up. Press the latches on either side of tool and remove bottom plate (A). 2. Unscrew the two Phillips screws and remove belt guard (B). 11