Hoover U6634900 Manual - Page 12
Replacing belt - belts
UPC - 719881163918
View all Hoover U6634900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
3-30 C D 3-31 3-32 B C C E 3. Remove agitator including end plates (C) and discard. 4. Inspect belt to ensure that it is in good condition. If belt is cracked, gouged or broken, replace it (see following section). 5. Insert brush roll through belt and position belt over gear teeth (D) on brush roll. 6. With curved ends down, slide end plates (C) of brush roll into slots (E) on tool. 7. Replace belt guard (B) making sure not to pinch brush bristles in guard. Turn agitator, making sure it rotates freely. Replace and tighten screws. 3-33 A Powered hand tool Belt replacement The powered hand tool belt is designed to last a long time and is not normally replaced. However, if the belt is cracked, gouged or broken, it should be replaced. 3-34 8. To replace bottom plate (A), insert the four tabs on edge of bottom plate into slots on front of tool. Pivot bottom plate down and snap closed. The belt can be seen through the top of the nozzle or by removing the bottom plate and belt guard (Figs. 3-28 and 3-29. Replacing belt When replacing belt, ask for HOOVER part No. 38528037. 1. Remove bottom plate, belt guard and brush roll as described in Figs. 3-28 through 3-30. 3-35 F E 2. Grasp turbine (E) and pull firmly to remove. 3. Remove belt from turbine pulley (F). Replace with new belt. 12 3-36 H G 4. With flat sides of turbine retainers (G) pointing down, slide retainers into grooves (H) in tool housing and snap into place. 5. Replace brush roll, belt guard, and bottom plate as described in Figs. 3-30 through 3-33.