Hoover UH20060 Manual - Page 10

3-11 3-12 3-13 B Remove 2 screws from bottom plate. Removing hood Lower cleaner base so it is flat on the floor. Remove 2 screws located at back of hood (A). Lift hood off. Remove 2 screws on agitator cover (B). 3-14 3-15 3-16 D Lift agitator cover off. C Grasp agitator (C) and pull up to remove from agitator cavity. E Slide belt (D) off agitator. Remove belt from motor shaft (E). Discard used belt. 3-17 3-18 G F 3-19 Position new belt on agitator brushroll With lettering on outside of belt, insert agitator brushroll through belt and position belt in groove (F) on agitator brushroll. Installing agitator brushroll Grasp agitator brushroll firmly and fit it into position by first sliding end opposite the belt into the rectangular slot (G) on side of cleaner. Pull other side of agitator brushroll into place. Reposition agitator cover over agitator. Replace 2 screws. 10