Hunter 28484 Operation Manual - Page 6
Caution, Warning
View all Hunter 28484 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3 • Assembling and Hanging the Fan Steps 3-1 - 3-2 Steps 3-3 - 3-4 6 Downrod Canopy Canopy Trim Ring Set Screw Low Profile Washer You can assemble your fan for standard mounting (steps 3-1 - 3-2) or for low profile mounting (steps 3-3 - 3-4). 3-1. To assemble the fan to hang down from a flat or angled ceiling, insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod. 3-2. Loosen the set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. Skip to Step 3-5. CAUTION: e adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. 3-3. Place the low profile washer (lip up) into the canopy. Be sure the green ground wire is pointing up toward the ceiling. Note: For low profile mounting, the downrod is replaced with the low profile washer. See Steps 3-3 - 3-4. 3-4. Align the holes in the washer with the holes in the adapter. Assemble securely with three #8-32 x 3/4" screws. 3-5. Raise the fan and place the hook on the ceiling plate through the U-shaped hole in the rim. Go to 4 • Wiring the Fan. WARNING: Fan may fall if not assembled as directed in these installation instructions. #8-32 x 3/4" Screw Step 3-5 U-shaped Hole Hunter Fan Company 42501 Sunset Boulevard.indd 6 10/24/2005, 11:04 AM 42501-01 • 10/24/05