Husqvarna 128DJx Owners Manual - Page 10

ASSEMBLY NOTE: Make sure unit is assembled correctly as shown in this manual. Fitting the J-handle S Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft. S Align the tab of the attachment (A) with the arrow on the coupling (B). B A S Push the attachment into the coupling until the attachment snaps into place. ENGINE S Slide the spacer into the slot in the loop handle. S Fit the nut, knob and screw. Do not overtighten. S Before using the unit, tighten the knob securely. S Attach the J--handle to the loop handle using the three screws as shown. S Make a final adjustment of the handle to a comfortable working position. Tighten the bolt/knob. WARNING: Only grass blades/ grass cutters or trimmer heads/plastic blades may be used when the J- handle is fitted. Saw blades must never be used with the J- handle. Assembling and dismantling the two--piece shaft Dismantling: S Loosen the coupling by turning the knob (at least three times). S Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling. C Assembly: S Loosen the coupling by turning the knob. 577387001 Rev. 2 1/6/11 English--- 10