Husqvarna 525iLST Owner Manual - Page 14
To start the product
View all Husqvarna 525iLST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
• Keep body parts away from the cutting attachment. Before you operate the product • Examine the work area to make sure that you know the type of terrain. Examine the slope of the ground and if there are obstacles such as stones, branches and ditches. • Do a general inspection of the product. • Do the safety inspections, maintenance and servicing that are given in this manual. • Examine the motor for dirt or cracks. Use a brush to clean the motor from grass and leaves. Use gloves when it is necessary. • Examine the trimmer head and cutting attachment guard for damages or cracks. Replace the trimmer head and cutting attachment guard if they are hit or if they have cracks. • Make sure that all nuts and screws are tight. • Make sure that all covers, guards, handles and the cutting equipment are correctly attached and not damaged before you start the product. To start the product 1. Put the product in the start position. 2. Push and hold the start button until the green LED comes on. 1. Push the mode button to set a limit to the maximum speed. The white LEDs comes on to show that the function is on. 2. Push the Mode button again to choose the next speed level. Automatic shutdown function The product has a shutdown function that stops the product if the product is not used. The green LED for start/stop indication goes off and the product stops after 180 seconds. Grass trimming with a trimmer head To trim the grass 1. Hold the trimmer head immediately above the ground at an angle. 3. Use the power trigger to control the speed. To limit the maximum speed with the mode button The product has a mode button. Withe the mode button the operator can limit the maximum speed. The mode button has 3 speed levels. A lower level increases the time of operation for the product. The mode button has 3 speed levels. A lower level increases the time of operation for the product. Use level 1 and level 2 if the operation does not require full speed/full power. If the operation condition requires full speed/full power, use level 3. Do not use a higher level than necessary for the operation. Do not push the grass trimmer line into the grass. 2. Decrease the length of the grass trimmer line by 10-12 cm (4-4.75 in) and decrease the motor speed to decrease the risk of damage to plants. 14 1920 - 001 - 28.11.2022