Husqvarna PZ6029D Owners Manual - Page 30

the radiator and debris screen. The fan will then, through the radiator to help clean debris

Get Husqvarna PZ6029D PDF manuals and user guides View all Husqvarna PZ6029D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

OPERATION 6. Move the steering controls outward to the locked (outer) neutral position. 7. Move the throttle to the middle position. Place controls in neutral position 8065-018 Set the throttle 8065-071 8. Turn the key to the RUN position and wait for the glow plug light to go out. Press in and turn the ignition key to the START position. If the engine fails to start after 10 seconds, the engine will stop cranking and the ignition switch must be turned off to reset the start sequence. When the engine starts, immediately release the ignition key back to the run position. NOTE: The fan will power up thirty seconds after the ignition is turned on and will blow air through the radiator to help clean debris from the radiator and debris screen. The fan will then reverse and continue in suction until the ignition is turned off. Turn the key to RUN and observe glow plug light 30 8065-071

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
OPERATION
30
8.
Turn the key to the RUN position and wait for the
glow plug light to go out. Press in and turn the
ignition key to the START position.
If the engine fails to start after 10 seconds, the
engine will stop cranking and the ignition switch
must be turned off to reset the start sequence.
When the engine starts, immediately release the
ignition key back to the run position.
NOTE: The fan will power up thirty seconds
after the ignition is turned on and will blow air
through the radiator to help clean debris from
the radiator and debris screen. The fan will then
reverse and continue in suction until the ignition
is turned off.
7. Move the throttle to the middle position.
6. Move the steering controls outward to the
locked (outer) neutral position.
8065-071
Set the throttle
8065-018
Place controls in neutral position
8065-071
Turn the key to RUN and observe glow plug light