Husqvarna PZ6029D Owners Manual - Page 45

maintenance 4. Double check belt routing to make sure it matches the routing decal, and that the belt does not have any twist. Correct if needed. 5. Adjust belt tension by turning the eyebolt until there is approximately 7/8" -1" of threads showing outside the nut. 6. Belt tension should be set to 60-70 lbs. 7. Replace belt shields on both mandrel housings and secure with fasteners. Pump Belt The pump belt is not adjustable. Replace the belt if it begins to slip from wear. Adjust belt tension Replacing Pump Belt Park the mower on a level surface. Engage the parking brake and disconnect negative cable from battery. Jack or hoist the rear of the unit off of the ground to access the bottom of the unit. Belt Removal/Installation 1 1. Remove the skid plate and the left drive tire. 2. With a ½" breaker bar and using the square opening in the idler arm, shift the arm counter clockwise to create slack in the belt. 3. Remove belt from the engine and pump pulleys. 4. To reinstall, reverse the above procedure using the belt routing diagram located on the left rear side of the hydraulic reservoir. 2 1. Belt routing decal 2. Idler release placement Pump belt removal 8065-054 8065-077 45