Husqvarna ST 124 Owner Manual - Page 11
To start the engine, electric start, Volt A.C. household current. Ensure
View all Husqvarna ST 124 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
5. Push the primer 1-3 times to start the booster pump. Use the booster pump for cold start in low temperatures. 8. When the engine is warm, slowly move the choke to the OPEN position. 6. Pull the recoil start handle. To start the engine, electric start WARNING: The product has a 120 Volt A.C. electric starter. Do not use the electric starter if your house is not a 120 Volt A.C. three-wire grounded system. Serious personal injury or damage to the product could occur. The electric starter has a threewire power plug, and is designed to use 120 Volt A.C. household current. Ensure that your house is a 120 Volt A.C. three-wire grounded system. If you are uncertain, consult a licensed electrician. CAUTION: Do not release the recoil start handle quickly. Move it back to the start position slowly. Note: Use an extension cord that is recommended for outdoor use, and that is not longer than 50 feet (15 m). 1. Release the drive engagement. Put the drive speed control lever in the first position. 2. Turn the fuel switch to the ON position. Note: If the recoil start handle has frozen, slowly pull out as much rope out of the starter as possible and release the recoil start handle. If the engine does not start, repeat the procedure or use the electrical starter. 7. Run the engine 30-40 seconds at idling speed before you start to throw snow. 1272 - 003 - 09.08.2019 11