Husqvarna ST 151 Owners Manual - Page 12
MAINTENANCE, Maintenance - belt
![]() |
View all Husqvarna ST 151 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
MAINTENANCE Maintenance NOTE: Determine the left and right sides of the machine from the normal operating position. Check for Loose Fasteners Clean / Inspect Snow Thrower Clean / Replace V-Belts Check / Replace Auger Blades and Scraper Bar Check Fuel Lines and Electrical Wires Check Engine Oil Level Change Engine Oil Inspect Muffler Check / Replace Spark Plug Empty Fuel Tank Adjusting the Control Cable Checking the Control Cable 1. Release the control bar to remove the slack in the control cable (Figure 21). NOTE: If the control cable is adjusted to position 2, ensure that the auger stops properly when the control bar is released Adjusting the Control Cable 1. With the control bar disengaged, unhook and move the control cable to the highest position. (Figure 22). 1 1 Position 2 2 3 1. Control bar Figure 21 IMPORTANT: The control cable must contain some slack when you disengage the control bar for the auger blades to stop properly. NOTE: You may need to adjust the control cable from position 1 (default) to position 2 if you notice belt slip when the control bar is engaged. Figure 22 1. Control bar 2. Adjuster link 3. Cable positions Position 1: Default position (Lower Hole as shown in illustration) 12
![](/manual_guide/products/husqvarna-st-151-owners-manual-9035669/12.png)