Husqvarna ST 151 Owners Manual - Page 16
Replacing the Drive Belt
![]() |
View all Husqvarna ST 151 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
MAINTENANCE Replacing the Drive Belt If auger v-belt becomes worn, oil-soaked, excessively cracked, frayed, or otherwise damaged, replace the belt. 1. Remove the drive side cover by removing the six screws as shown in (Figure 34). 5 4 6 7 4. Install the new auger v-belt and drive pulley, routing it as shown in Figure 35. NOTE: Route the new auger v-belt first around the engine pulley, then the idler pulley, and finally around the drive pulley while pressing down on the front of the idler arm. (Figure 35). 5. Install the drive side cover with the screws removed in step 1. NOTE: Ensure belt keeper on the plastic side panel engages between belt and frame before bolting down. 1 2 2 3 1 3 2 Figure 34 1. Drive side cover 2. Screw 3. Drive pulley 4. Idler arm 5. Idler pulley 6. Engine pulley 7. Auger V-Belt 2. Remove drive pulley from the auger shaft. NOTE: Nut is welded to drive pulley and has left handed threads. 3. Remove the auger v-belt from the drive pulley. 4 Figure 35 1. Idler arm 2. Idler pulley 3. Engine pulley 4. Drive pulley NOTE: Ensure that the auger v-belt is properly adjusted and operating; refer to Checking the Control Cable and Adjusting the Control Cable in the Maintenance section of this manual. 16
![](/manual_guide/products/husqvarna-st-151-owners-manual-9035669/16.png)