Husqvarna ST 151 Owners Manual - Page 15
Set top cover in place and snap three top cover clips
![]() |
View all Husqvarna ST 151 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
MAINTENANCE 15. Disconnect the spark plug wire from the spark plug (Figure 31). 16. Clean around the spark plug. 17. Remove the spark plug from the cylinder head. 1 19. Install the spark plug and torque it to 20-22 ft-lb (27-30 N-m). 20. Connect the spark plug wire to the spark plug (Figure 31). 21. Reattach primer bulb tube to primer bulb and electrical wires on back ignition switch of rear upper cover (Figure 30). 22. Set rear upper cover in place so the two screw holes line up with the rear lower cover and side covers (Figure 33). 1 Figure 31 2 1. Spark plug wire IMPORTANT: Replace a cracked, fouled, or dirty spark plug. Do not clean the electrodes because grit entering the cylinder can damage the engine. 18. Set the gap on the plug to 0.030 inch (0.76 mm) (Figure 32). 0.030 inch (0.76 mm) Figure 32 Figure 33 1. Rear upper cover 2. Screw 23. Reattach two screws through the rear covers and into the clip on the side cover (Figure 28). 24. Remove top oil fill cap. 25. Set top cover in place and snap three top cover clips into the rear upper cover (Figure 29). 26. Reinstall top oil fill cap. 27. Reinstall two screws in the side covers that attach to the clips on the top cover. 28. Reinstall two screws in the plenum that attach to the top cover (Figure 28). 29. Reinstall discharge chute with the hardware removed in step 5. 15
![](/manual_guide/products/husqvarna-st-151-owners-manual-9035669/15.png)