Husqvarna V548 Owner Manual - Page 13
To operate the product, To start the engine on, engage and disengage the parking brake
View all Husqvarna V548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
5. Push in and turn the ignition key to the start position. 4. Carefully push the 2 control levers forward. The product will start to move forward. The forward speed increases the more the 2 control levers are pushed forward. Note: Do not keep the ignition key in the start position for more than 5 seconds at a time. If the engine does not start, wait 15 seconds before you try again. 6. When the engine starts, immediately release the ignition key to the run position. 7. Slowly push in the choke control if the choke was used. 8. Let the engine run at ½ throttle for 3-5 minutes before you apply heavy load. 9. Push the throttle control to the full throttle position. To operate the product 1. Start the engine. Refer to To start the engine on page 12. 2. Push down the 2 control levers to engage the OPC. 5. Carefully pull the 2 control levers rearward. The product will start to move rearward. The rearward speed increases the more the 2 control levers are pulled rearward. 6. Put the 2 control levers in neutral position to decrease the speed and stop the product. 7. Do the steps that follow to turn left or right when you go in a forward direction. a) Pull the left control lever rearward in the direction of the neutral position to make the product turn left. The more you pull the left control lever rearward, the more the product will turn left. 3. Disengage the parking brake. Refer to To engage and disengage the parking brake on page 12. b) Pull the right control lever rearward in the direction of the neutral position to make the product turn right. The more you pull the right control lever rearward, the more the product will turn right. 1994 - 002 - 05.12.2022 8. Do the steps that follow to make a zero turn. 13