Husqvarna V548 Owner Manual - Page 25
To lubricate the front wheels, To lubricate the cutting deck spindles, Troubleshooting
View all Husqvarna V548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Refer Lubrication to F Replace the oil filter. Always use good quality grease. Always use recommended oil, refer to Technical data on page 29. To lubricate the front wheels • Remove the dust cap (A). Grease the nipple (B) with a grease gun until grease comes out from the top washer. A B Interval Month ly Yearly Each 50 hours X X Each 250 hours X Each 500 hours X To lubricate the cutting deck spindles 1. Set the cutting deck in mow position. 2. Lubricate each cutting deck spindle 2-3 strokes. C • Lubricate the joint bearing of the front wheels (C) with a grease gun until grease comes out. Note: Use a grease gun with a rubber hose when you lubricate the cutting deck spindles. Troubleshooting Troubleshooting schedule If you cannot find a solution to your problems in this operator's manual, speak to your Husqvarna service agent. Problem Engine does not start. Cause The drive of the blades is engaged. Refer to PTO (Power TakeOff) button on page 4. Steering controls are not locked in the neutral position. The battery is too weak. Refer to To charge the battery on page 18. There is dirt in the carburetor or the fuel line. The fuel filter or fuel line is clogged. The ignition system is damaged. Incorrect neutral adjustment. Refer to To adjust the neutral position on page 20. 1994 - 002 - 05.12.2022 25