Husqvarna V548 Owner Manual - Page 20
To adjust the neutral position, Loosen the top nut to make the rear wheel go
![]() |
View all Husqvarna V548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
7. Measure the distance between the ground and the bottom of the blade tip on the side opposite to the discharge side. The distance must be the same as the distance for the discharge side. If adjustment is necessary, adjust the 2 front nuts until the 2 side to side distance are equal. Tighten the 2 front nuts. 7. Adjust the top nut with a 9/16" socket or wrench until the rear wheel is stationary when the control levers are in the neutral position. 8. Turn the blades to align with the cutting deck front to rear. 9. Adjust the 2 rear nuts until the rear blade tips are set 1/4-3/8 in. / 6.4-9.5 mm higher than the center blade tips. 10. Measure the distance between the ground and the front and rear edges of the cutting deck. Make sure that the rear edge is 1/5 in. / 4-6 mm higher than the front edge. To adjust the neutral position 1. Use a lifting device to lift up the rear part of the product until the rear wheels are off the ground. 2. Put a stable object below the product and make sure that the product cannot move forward or rearward. 3. Loosen the 2 socket head cap screws found on the pumps at the front of the product for the side where adjustment is necessary. A 3/8" hex key is necessary. Also an extension or long hex key may be necessary. a) Tighten the top nut to make the rear wheel go in reverse. b) Loosen the top nut to make the rear wheel go forward. Note: Push the control levers and let them release back into neutral position during the adjustment procedure. 8. Torque the 2 socket head cap screws to 75 ± 15 ft-lb. 9. Do adjustment for the other side if it is necessary. To adjust the neutral switches 1. Engage the parking brake. 2. Loosen the jam nuts on the left and right side of the product with a wrench. Note: Do not remove the 2 socket head cap screws. 4. Start the product. 5. Engage the OPC levers. 6. Disengage the parking brake. 3. Adjust the neutral bolt on the left side of the product until the plunger on the neutral switch is flush with the surface of the neutral switch. 4. Adjust the neutral bolt on the right side of the product until the bolt does not touch the plunger. 5. Do the steps that follow on the right side of the product. WARNING: Keep fingers, clothes and loose items away from the pump fans. 20 1994 - 002 - 05.12.2022
![](/manual_guide/products/husqvarna-v548-owner-manual-1153757/20.png)